Finally checked into the VA MARS net. The net started late and I had almost given up on it. I’m going to try and check in again tomorrow morning. I need to get around to raising the height of my inverted vee – I think it will better help my signal get out.

I was able to catch W1AA (Henry and Whitey) and their activation of the Highland Lighthouse (USA 110) out on Cape Cod. Whitey, K1VV, is usually out ever weekend doing a lighthouse activation – always has a nice signal.

Had a very nice Radio Merit Badge class for a young Scout out at Fort Monroe in the afternoon. I setup my 10′ x 10′ shelter and the ARSIB. Initially I planned on setting the G5RV (like during the W4M Memorial Day Special Event) but the wind was quite heavy, so I opted to put up the homebrew vertical dipole. To get some height on the antenna, I attached it to the top of the painter’s pole. Before I had a chance to tie down the pole, a gust of wind knocked the antenna down. The fall caused the feedline connection to break off. Not good. However, with a little bit of wire and some electrical tape, I was able to reattached the feedline connection. Now the antenna was low to the ground and I was a little concerned about it’s performance. The Scout arrived and we started reviewing the Radio Merit Badge requirements. I was able to easily tune WWV on 15 MHz and was also able to find a CW QSO in progress on 40M. Also demoed a bit of CW using my MFJ paddle that has a speaker built in. After we’d reviewed all the requirements, it was time for the HF QSO. The Scout called CQ and after a few tries, received a reply from Charlie, N1MUQ, in Stamford, CT. Charlie had a booming, solid signal and the Scout was able to successfully complete the QSO. We then moved to my mobile VHF rig and the Scout had a nice QSO with Randy, WB7URZ located up in Gloucester. Even with the antenna setup issues, the Radio Merit Badge session was a success and I think both the Scout and I had a good time.